2008 Chevy Silverado Lifter Noise

2008 Chevy Silverado Lifter Noise. Sure enough after pulling the valve covers and turning the engine over, the rocker on #4 cylinder intake valve was not moving verifying the collapse. This time the misfire remained and had to call for a tow.

NOISY LIFTERS? Motor Flush Does It Work? HOW TO DO IT YOURSELF YouTube from www.youtube.com

I purchased a 2006 1500 silverado, i tried to but it n 2006 but it would have cost me $49,000. We noticed a knock in about 1000 miles later and took it back to the dealership. 2000 chevy 1500 4.8 tapping noise under valve cover.removed cover all rocker arms look and feel correct.

Source: offerup.com

2008 chevy silerado has a terrible grinding noise in reverse and doesn't work at all? The vehicle was taken to an authorized dealer for diagnosis and they recommended that.

Source: chevroletforum.com

In 20 seconds you can become part of the worlds largest and oldest community discussing general motors, chevrolet and gmc. 2008 chevy silverado 1500 5.3 lifter repair.

Source: www.funnycat.tv

Whining is another common complaint and is usually the front pump, bearing or planetary set. Quick video showing you how to quite a lifter tick on a 5.3 vortec engine questions?

Source: www.performancetrucks.net

The planetaries usually make noise in gear and at speed. Listen to that dead lifter.

Source: www.autoserviceprofessional.com

Flush out the old oil. Sounds like a lifter hammering.

Source: www.hptuners.com

Driving into work yesterday i started hearing a series of clattering and wondered what it. In 2008 i found it for $19000.

Source: www.hotrod.com

The most recently reported issues are listed below. The contact stated while starting the vehicle, a loud ticking noise emitted from the engine compartment intermittently.

Source: www.amazon.com

Please also check out the statistics and reliability analysis of the 2008 chevrolet silverado 1500 based on all problems reported for the 2008. Oil presure was all over the place would go from 65 psi to 25 psi at same rpm.

Source: www.funnydog.tv

So, when your engine is not running the oil can leak out of the lifter, causing the ticking. Sounds like a lifter hammering.

Source: www.mautofied.com

2000 chevy 1500 4.8 tapping noise under valve cover.removed cover all rocker arms look and feel correct. Posted by kevin on oct 10, 2014.

Source: www.ebay.com

Engine was ticking on top end sounded like a lifter tick and slight deeper knock in bottom end. Its common to hear your lifters ticking on a early morning cold start with these trucks that goes away after a few seconds.

Source: www.youtube.com

The contact owns a 2008 chevrolet silverado 1500. I know of the piston slap but i dont think this is piston slap.

Sounds Like A Lifter Hammering.

Quick video showing you how to quite a lifter tick on a 5.3 vortec engine questions? Two problems related to engine noise have been reported for the 2008 chevrolet silverado 1500. Oil presure was all over the place would go from 65 psi to 25 psi at same rpm.

Its Common To Hear Your Lifters Ticking On A Early Morning Cold Start With These Trucks That Goes Away After A Few Seconds.

I know of the piston slap but i dont think this is piston slap. This noise is only noticeable at idle and a slight increase in rpm will diminish the noise. Unscrew the cap under the car and place a container or bowl under the cap.

#7 · May 21, 2014.

But let me know what you think it is i. In 20 seconds you can become part of the worlds largest and oldest community discussing general motors, chevrolet and gmc. We noticed a knock in about 1000 miles later and took it back to the dealership.

Discussion Starter · #1 · Nov 22, 2015.

In 2008 i found it for $19000. The planetaries usually make noise in gear and at speed. I got a 2008 silverado 4x4 1500 with the flex fuel 5.3.

I Purchased A 2006 1500 Silverado, I Tried To But It N 2006 But It Would Have Cost Me $49,000.

I immediately shut the engine off and restarted it multiple times. I knew more than likely it was a collapsed lifter. Posted by kevin on oct 10, 2014.